Q-See QT426 User Manual

MAIN MENU SETUP GUIDE QT426 User Manual
33 | Page
4.5.3 Video Loss
Step 1: Enter into system configurationalarm configurationvideo loss; refer to Fig 4-26:
Fig 4-26 Alarm Configuration-Video Loss
Step 2: The setup steps of video loss trigger are familiar with alarm handling; user can refer to Chapter 4.5.1 Sensor
alarm handling for more details.
Step 3: User can setup all channels with same parameters, checkmark “all”, then to do relevant setup.
Step 4: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button to
exit current interface.
4.5.4 Other Alarm
Fig 4-27 Other Alarm
Step 1: Enter into system configurationother alarm; refer to Fig 4-27:
Step 2: Select a hard disk in the pull down list box, when the disk capacity is lower than that value, there will appear
some text information on the lower right of the live image.
Step 3: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button to
exit current interface.

Q-See QT426 Specifications

General

Brand	Q-See
Model	QT426
Category	DVR
Language	English