MAIN MENU SETUP GUIDE QT426 User Manual
32 | Page
Step 5: In the Area interface, user can drag slide bar to set the sensitivity value (1-8), the default value is 4. The
higher the value the higher sensitivity you get. Since the sensitivity is influenced by color and time (day or night),
user can adjust its value according to the practical conditions; click
icon, set the whole area as detection area;
click
icon, the set detection area will be cleared; click icon, user can test whether the sensitivity value and
motion area are suitable to current conditions（refer to following picture）; Click
icon, to save the setting; click
icon, exit current interface.
Note: when user drags mouse to set motion detection area, they have to click
icon to clear
current detection area first, and then set the area.
Step 6: User can setup all channels with same parameters, checkmark “all”, then to do relevant setup.
Step 7: Click “default” button to restore default setting; click “apply” button to save the setting; click “exit” button to
exit current interface.
② Schedule
Step 1: Enter into system configurationalarm configurationschedule; refer to Fig 4-25:
Fig 4-25 Alarm Configuration-Schedule
Step 2: The setup steps of alarm schedule are similar to schedule; user can refer to 4.4.1 Schedule for details.
To Next Page
Loading...
Need help?
General
