EasyManuals Logo

Q-See QT426 User Manual

Q-See QT426
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
REMOTE SURVEILLANCE QT426 User Manual
56 | Page
Setting up MYQ-SEE DDNS:
NOTE: Before you setup DDNS you must first set up Port Forwarding as directed in Section 7.3 PORT
FORWARDING. Once you have enabled Port Forwarding, you can configure your DDNS information by
following these steps:
a. Using a computer that is connected to the same network as your Q-See DVR, use your IE Browser to go to
http://myq-see.com.
b. Click on the New User? Link at the bottom of the page (http://myq-see.com/reg.asp).
c. Complete the registration process by following the on-screen directions and click the [Submit] button at the
bottom of your screen (Fig 7-8).
Fig 7-8 Registration

Table of Contents

Other manuals for Q-See QT426

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Q-See QT426 and is the answer not in the manual?

Q-See QT426 Specifications

General IconGeneral
BrandQ-See
ModelQT426
CategoryDVR
LanguageEnglish

Related product manuals