QNAP QMiroPlus-201W User Manual

5. Click OK.
Important
The following settings are changed when the router is switched to AP mode.
• The router is unbound from the QNAP ID.
• The router is removed from the QNAP organization and QuWAN. You must reconfigure
the QuWAN settings if you enable the router mode again.
6. Run Qfinder Pro on a computer that is connected to the same local area network.
Note
To download Qfinder Pro, go to https://www.qnap.com/utilities.
7. Locate the router in the list and double-click the name or IP address.
The login screen appears.
8. Enter the local account credentials of the router.
9. Click Login.
Note
QuRouter displays only information related to access point settings such as network, wireless,
firmware, and system settings.
Locating the Router
This section describes how to locate an on-premise router by remotely activating the LED indicator on the
router.
1. Go to QMiro Devices.
2. Identify the router in the QMiro Device List.
3.
Click .
The Settings - [Device_Name]-[Location] window appears.
4. Click Start.
The router LED flashes 5 times.
Enabling the Router LED
1. Go to QMiro Devices.
2. Identify the router in the QMiro Device List.
3.
Click
.
The Settings - [Device_Name]-[Location] window appears.
4.
Click next to LED status.
The router LED is enabled.
QMiroPlus-201W User Guide
System Configuration 31

QNAP QMiroPlus-201W Specifications

General

Brand	QNAP
Model	QMiroPlus-201W
Category	Network Router
Language	English