You can configure WPS by pressing the WPS button located on the front panel of the device (see Front
Panel). Alternatively, you can configure WPS through QuRouter; for details, see Configuring Wi-Fi Protected
Setup (WPS).
Operation User Action Result
Enable WPS 1. Press the WPS button located on the
router for 3 seconds.
2. Enable WPS on the client device.
Tip
The WPS feature might be
labelled differently, depending on
the product.
The function is typically located in
the Wi-Fi settings page.
The WPS protocol is enabled and the client
device joins the network.
Rear Panel
No. Component
1 Storage power button
2 USB 3.2 Gen 1 Type-A ports
3 2.5 Gigabit Ethernet activity LED
4 2.5 Gigabit Ethernet port
5 2.5 Gigabit Ethernet speed LED
6 Power input
7 Reset button
8 WAN port
9 LAN ports
QMiroPlus-201W User Guide
Product Overview 11
To Next Page
Loading...
