QNAP QMiroPlus-201W User Manual

Setting User Action
Enable DHCP server Configure the DHCP server settings.
• Start IP address: Specify the starting IP address in a range allocated to
DHCP clients.
• End IP address: Specify the ending IP address in a range allocated to
DHCP clients.
• Lease time: Specify the length of time that an IP address is reserved for a
DHCP client. The IP address is made available to other clients when the
lease expires.
• DNS server 1: Assign an IP address for the primary DNS server.
• DNS server 2: Assign an IP address for the secondary DNS server.
Note
QNAP recommends specifying at least one DNS server to
allow URL lookups.
Reserved IP Table Click Add to configure a reserved IP table.
Specify the following:
• Device name
• IP address
• MAC address
3. Click Apply.
QuRouter updates the LAN port settings.
Routing Table
The Network > Routing > Routing Table page provides status information about configured route entries
from the following sources:
• Directly connected networks
• Dynamic routing protocols
• Statically configured routes
Static Route
You can create and manage static routes in the Static Route section of network settings. Under normal
circumstances, QuRouter automatically obtains routing information after it has been configured for internet
access. Static routes are only required in special circumstances, such as having multiple IP subnets located
on your network.
Adding a Static Route
1. Go to Network > Routing > Static Route .
2. Click Add Static Route.
The Add Static Route window appears.
QMiroPlus-201W User Guide
Network Settings 39

QNAP QMiroPlus-201W Specifications

General

Brand	QNAP
Model	QMiroPlus-201W
Category	Network Router
Language	English