b. Tap Apply.
QuRouter saves the router location.
15. Tap Next.
16. Configure the wireless domain settings.
a. If the router and mobile device locations are not the same, the Incompatible Wireless Domain
Settings window appears.
b. Tap OK.
c. Select the current location of the router.
d. Tap Apply.
17. Specify a new SSID and password for the router.
18. Tap Apply.
A confirmation message appears informing you to connect to the updated router SSID in the Wi-Fi
settings page of the mobile device.
19. Tap Finish.
The Firmware Update page appears.
20. Tap Next.
QuRouter updates the QTS firmware.
21. Click OK.
The QTS Storage Settings page appears.
22. Configure the QTS storage settings.
Tip
Skip this step if the storage feature is not enabled or QTS is already configured.
a. Click Start.
The Install 2.5-inch Hard Drive page appears.
b. Install 2.5-inch drives.
For details, see Installing 2.5-inch Hard Drives or Solid-State Drives on 2.5-inch Trays.
Tip
Click Drive compatibility list for the list of compatible drive models.
The Check Drive Status page appears.
c. Verify if the drive LED is green.
For details, see LEDs.
d. Click Next.
QuRouter detects the installed disks on the router and displays a drive formatting confirmation
message.
e. Click OK.
QuRouter formats the installed disks and displays the Drive Storage Settings page.
f. Specify the RAID type.
QMiroPlus-201W User Guide
QuRouter App 57
To Next Page
Loading...
Need help?
General
