quadient IN-360 Series - How to Change System Time-Outs

2. Specify the length of each time-out using the keypad and press [OK] to display the
next screen, until the Summary screen is displayed.
3. Press [OK] to exit.
This is a user setting that only lasts as long as you are logged in.
Setting Default Time-Outs
How to Change System Time-Outs
To change the system time-Outs:
1. In supervisor mode (see How to Log in as Supervisor on page 122)
Press and select the path: Default user settings Time-Out settings
The Time-out setting screen is displayed.
2. Specify the length of each time-out using the keypad and press [OK] to display the
next screen, until the Summary screen is displayed.
Use the [C] key to clear old settings then enter a new value.
3. Press [OK] to validate.
130
| Page 130 | Jan-13-2017 09:24 |
8
Configuring your Mailing System