quadient IN-360 Series - How to Clean the Print Heads Automatically (as Supervisor); How to Implement Wiper Process

How to Clean the Print Heads Automatically (as Supervisor)
To clean the print heads automatically:
1. In supervisor mode (see How to Log in as Supervisor on page 122):
Press and select the path: Maintenance Cartridge Cleaning process
The cleaning starts automatically.
Wiper Process
How to Implement Wiper Process
1. In supervisor mode (see How to Log in as Supervisor on page 122):
Press and select the path: Maintenance Cartridge Wiper Process
2. Open the top cover and remove the headset (see How to Change the Ink Cartridge
on page 172).
3. Press [OK] twice to start the carriage motor.
4. Check wiper and clean if necessary, then press [OK].
5. Re-install the headset and check it is back in replacement position.
6. Close the top cover and press [OK].
170
| Page 170 | Jan-13-2017 09:24 |
10
Maintaining your Mailing System