Time and Date Management8.12
Daylight Savings Time Transitions
Your Mailing System normally auto-adjusts to Daylight Savings Time. However, if a manual
adjustment is necessary, you can use either of the following procedures to correct the
Mailing System time:
• As a user: How to Unlock the PSD on page 69
• As supervisor: How to Check/Adjust the Machine Time and Date on page 148.
Time and Date Setup
Time and date are required for postage and are provided by the postal authorities. As a
result, you cannot manually adjust the system time and date.
However, you can ask the system to check the current time and date and display them.
See also
• Automatic Date Advance on page 142.
To check the time and date, make sure the connection to the Postal
Services is available. See How to Set the Postal/Online Services
Connection on page 146.
How to Check/Adjust the Machine Time and Date
To check the current time and date:
1. In supervisor mode (see How to Log in as Supervisor on page 122):
Press and select the path: Machine Settings Date and Time
If you are processing postage at the time when the system clock
adjusts for daylight savings time, the Mailing System will wait until
you are finished before displaying the new time.
2. Select Audit call to adjust the time.
The system adjusts its time if necessary and displays time and date values.
148
| Page 148 | Jan-13-2017 09:24 |
8
Configuring your Mailing System
To Next Page
Loading...
