Running [Pass Through] Mail3.5
In Running [Pass Through] Section
This section describes how to use the [Pass through] type of imprint, for:
• Only conveying mail, for counting or testing purposes.
See also
• About the use of this Type of imprint, see Choosing a Type of Imprint on page 25.
Setting [Pass through] Mail processing
The procedure below outlines steps required to process mail.
You must begin with selecting the Type of imprint to gain access to the corresponding
parameters and be able to run mail.
Make sure you have completed the preparation steps mentioned
in Preparing and Starting your Work Session on page 27.
How to Set [Pass Through] Mail processing
Main setting:
1. Make sure you are on the home screen of the [Pass through] type of imprint.
The type of imprint is indicated at the top of the home screen as illustrated.
46
| Page 46 | Jan-13-2017 09:24 |
3
Processing Mail
To Next Page
Loading...
