2. Insert the envelope into the mail path against the rear-guide wall, with the side to be
printed facing upwards.
If you want to seal the envelope, first engage the flap into the
moistener (option). Do not try to moisten self-adhesive envelopes.
3. The Mailing System applies postage and the envelope is ejected.
Applying Postage for [Payment Surcharge Entry] Mail
Sequence of Settings for [Payment Surcharge Entry] Mail
The procedure below outlines steps to enter the surcharge amount manually.
The sequence is identical to Applying Postage for Standard Mail on page 33, except for
the following:
• Postage must be set manually to the desired amount.
Make sure you have already completed the preparation steps
mentioned in Preparing and Starting your Work Session on page
27.
3
Processing Mail
39
| Page 39 | Jan-13-2017 09:24 |
To Next Page
Loading...
