2. Select Add Funds.
The Add Funds screen is displayed.
3. If the system asks for a PIN code, enter the code using the keypad and press [OK].
4. Enter the amount of postage to add using the keypad (use C to clear a digit).
5. Press [OK] to start the connection to the Postal Server.
If the funding process is successful, the system displays a successful message.
If funding fails, the system displays a failure message and the amount that you
may actually add, depending on your postal account balance.
In the case of a communication error, the amount previously
entered cannot be changed. Check connection settings (see
Connection Settings on page 209).
6. You can open the Funds Used / Funds Available screen to check your account
balance once the transaction is complete (see How to Check the PSD (Meter)
Funds on page 95).
See also
- You can set the Mailing System to ask for a PIN code for funding: see How
to Set/Cancel a Funding PIN Code on page 102.
5
Money Operations
97
| Page 97 | Jan-27-2023 01:28 |
To Next Page
Loading...
