2. Select 'No account with access control'.
3. Press [OK] to confirm.
4. If required, enter the PIN code and press [OK].
Setting up 'Account'
In 'Account' Mode, users must select an account before they can process their mail.
The user can change accounts at any time during mail processing.
If only one account is available, the Mailing System automatically
selects it at start up.
Implementing the 'Account' Mode
1. Follow the steps outlined in How to Display and Change the 'Account Mode' on
page 119 and select the 'Account' Mode.
2. Create accounts as indicated in How to Create an Account on page 119.
When you activate the 'Account' Mode, the system creates an
account by default.
6
Accounts and Access Control
113
| Page 113 | Jan-27-2023 01:28 |
To Next Page
Loading...
