6 QXS 12G Site Planning Guide
Standard features of the cabinet include:
• Front and rear door that can be closed and locked
• Vertical rails, with mounting holes, to allow installation of storage
• 40U high cabinet and 19 inches/48.3cm wide
• Four rolling coasters/wheels
• Four leveling pads (bottom of cabinet)
• A stabilizing foot (after installation of permanent location)
• Access for storage cabling
• AC or DC power source (2 each)
NOTE: Install the applicable storage rack on the cabinet support rails, then install the
chassis/expansion storage unit, and then populate the unit with applicable drives (HDDs or SSDs).
Ensure to place the cabinet in a location that allows sufficient space to maintain and service (remove
and replace parts) the applicable units within the cabinet.
Cabinet Height
Cabinets heights might vary. A common cabinet is 40U high.
• A height of 1U equals 1.75-inches (44.45-mm).
• So, a 40U cabinet will have 70 inches (1778 mm/1.778 km) of storage space.
WARNING! Risk of bodily harm and/or injury. Comply with the following:
• Always populate the cabinet from bottom to top to prevent tipping.
• If a cabinet must be moved, use adequate personnel and/or a forklift to relocate the cabinet.
• Push the cabinet from the front when moving.
• A fully populated cabinet can weigh almost 3000 pounds (1360.777kg).
• Cabinets are hard to move, even on a flat surface/floor.
• If moving a cabinet on an incline, always remove the top-half storage arrays/devices to prevent
from tipping.
To Next Page
Loading...
Need help?
General