QXS-484 12G System Specifications 35
5U84-Drive RAID and Expansion Chassis Weight
Tab l e 17 identifies the weight of the QXS-484 12G RAID and expansion chassis.
Bezel
The 5U84 chassis ships with the bezels (2 each) installed on the upper drawer (Drawer 0) and the
lower drawer (Drawer 1). The bezel, comprised of a vented cover attached to an electro-magnetic
interference (EMI) shield, is pre-installed at the factory.
Instructions for replacing (removing/installing) the bezel are provided in the
QXS 12G Hardware
Installation and Maintenance Guide
.
CAUTION: The bezel should be properly installed while the chassis is in operation to ensure
adequate EMI protection for the drives.
Depth from face of Ops panel to rearmost chassis extremity 981 mm 38.62 in
Note: The 5U84 uses 3.5" LFF disks in the DDIC carrier. It can also use 2.5" SFF disks with 3.5" adapter in the
DDIC.
Ta bl e 1 6 Chassis Dimensions
Specification Metric Unit Imperial Unit
Ta b le 1 7 Chassis Weights
CRU/Component 5U84 (kg/lb)
Storage chassis (empty) 64/141
Disk drive carrier 0.8/1.8
Dummy disk drive carrier (air management sled) -
2U Power Supply Unit (PSU) -
5U Power Supply Unit (PSU) 2.7/6.0
5U Fan 1.4/3.0
Controller (module in RAID chassis) 2.6/5.8
Expansion IOM (module in expansion chassis) 1.5/3.3
RAID chassis (fully populated with modules: maximum weight) 135/298
Expansion chassis (fully populated with modules: maximum weight) 130/287
Note 1: Weights shown are nominal, and subject to variances.
Note 2: 5U rail kits add significantly more weight.
Note 3: Weights may vary due to different power supplies, controllers/expansion IOMs, and differ-
ing calibrations between scales.
Note 4: Weights may vary due to actual number and type of drives (SAS or SSD) and air manage-
ment modules installed.
To Next Page
Loading...
Need help?
General