Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 134 / 247
<bfr> 0 TA buffer of unsolicited result codes defined within this command is flushed to the
TE when <mode> 1...2 is entered (“OK” response shall be given before flushing
the codes)
1 TA buffer of unsolicited result codes defined within this command is cleared when
<mode> 1...2 is entered
Unsolicited result code:
+CMTI: <mem>,<index> Indicates that new message has been received
+CMT: [<alpha>],<length><CR><LF><pdu> Short message is outputted directly
+CBM: <length><CR><LF><pdu> Cell broadcast message is outputted directly
+CBMI: <mem>,<index> Cell broadcast message is stored and routed to the TE
Example
AT+CMGF=1 //Set SMS message format as text mode
OK
AT+CSCS="GSM" //Set character set as GSM which is used by the TE
OK
AT+CNMI=1,2,0,1,0 //Set SMS-DELIVERs are routed directly to the TE
OK
+CMT: "+8615021012496",,"2014/03/18 17:07:21+32"
This is a test from Quectel. //Short message is outputted directly when SMS is incoming.
9.13. AT+CSCB Select Cell Broadcast Message Types
AT+CSCB write command selects which types of CBMs are to be received by the ME. The command
writes the parameters in non-volatile memory.
AT+CSCB Select Cell Broadcast Message Types
Test Command
AT+CSCB=?
Response
It returns supported modes as a compound value.
+CSCB: (list of supported <mode>s)
OK
Read Command
AT+CSCB?
Response
+CSCB: <mode>,<mids>,<dcss>
OK
NOTE
Quectel
Confidential