Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 60 / 247
4.5. AT+CIND Command of Control Instructions
Parameter
<descr> String type, instructions state, values refer to the following notes
<ind> Integer types, instructs event, related to the value of the <descr>
1. UG95 module does not support this function.
2. The value of <descry> and <ind>:
<descr>
<ind>
"call": call status indication
0: no call
1: call
"roam": roaming indicator
0: Registered with the ownership or unregistered network
1: Registered to the roaming network
"signal": signal strength indication
0-5: According to the from weak to strong, divided into five levels
"service": network service status
indicator
0: Not registered on the network
1: Registered to the known network
"GPRS coverage": PS domain
registration instructions
0: Unregistered on PS domain
1: Registered on PS domain
Example
AT+CIND=?
+CIND: ("call",(0,1)),("roam",(0,1)),("signal",(0-5)),("service",(0,1)),("GPRS coverage",(0,1))
AT+CIND Command of Control Instructions
Test Command
AT+CIND=?
Response
+CIND: (<descr>,(list of supported
<ind>s))[,(<descr>,(list of supported
<ind>s))[,...]]
OK
Read Command
AT+CIND?
Response
+CIND: <ind>[,<ind>[,...]]
OK
If error is related to ME functionality:
+CME ERROR: <err>
NOTES
Quectel
Confidential