UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 139 / 247
+QCMGS: 190
OK
AT+QCMGS= "15056913384",120,2,2 <CR> //Send the second segment of the concatenated SMS.
>EFGH<Ctrl-Z>
+QCMGS: 191
OK
9.17. AT+QCMGR Read Concatenated Messages
The function of AT+QCMGR is similar to AT+CMGR, except that the message to be read is a segment of
concatenated messages, parameters: <uid>,<msg_seg> and <msg_total> would be shown in the result.
You should concatenate several segments to a whole concatenated message according to these three
parameters. Similar to AT+QCMGS, and AT+QCMGR is only used in text mode (AT+CMGF=1).
AT+QCMGR Read Concatenated Messages
Write Command
AT+QCMGR=<index>
Response
If text mode (+CMGF=1) and command is executed
successfully:
For SMS-DELIVER:
+QCMGR:
<st
at>,<oa>,[<alpha>]
,<sct
s>[,<tooa>
,<fo>,<pid>
,<dcs>,<
sca>,<tosca>,<length>][,<uid>,<msg_seg>,<msg_total>]
<CR><LF><data>
OK
For SMS-SUBMIT:
+QCMGR:
<st
at>,<da>,[<alpha>]
[,<toda>,<
fo>,<pid>,<
dcs>,
[<vp>],
<
sca>,<tosca>,<length>][,<uid>,<msg_seg>,<msg_total>]
<CR><LF><data>
OK
For SMS-STATUS-REPORTs:
+QCMGR:
<stat>,<fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st>
OK
For SMS-COMMANDs:
To Next Page
Loading...
Need help?
General
