Quectel UG Series User Manual

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 24 / 247
2.18. A/ Repeat Previous Command Line
A/ repeats previous AT command line, and "/" acts as the line terminating character.
Example
ATI
Quectel
UGxx
Revision: UGxxENAR01A01E1G
OK
A/ //Repeat previous command
Quectel
UGxx
Revision: UGxxENAR01A01E1G
OK
2.19. ATS3 Set Command Line Termination Character
ATS3 determines the character recognized by the module to terminate an incoming command line. It is
also generated for result codes and information text, along with character value set via ATS4.
A/ Repeat Previous Command Line
Execution Command
A/
Response
Repeat Previous Command
Reference
V.25ter
ATS3 Set Command Line Termination Character
Read Command
ATS3?
Response
<n>
OK
Write Command
ATS3=<n>
Response
This parameter setting determines the character recognized
by TA to terminate an incoming command line. The TA also
returns this character in output.
OK
Quectel
Confidential

Quectel UG Series Specifications

General

Brand	Quectel
Model	UG Series
Category	Control Unit
Language	English