Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 159 / 247
Parameter
10.9. AT+CGPADDR Show PDP Address
The AT+CGPADDR write command returns a list of PDP addresses for the specified context identifiers. If
no <cid> is specified, the addresses for all defined contexts are returned.
Parameter
<L2P> A string parameter that indicates the layer 2 protocol to be used between the TE and MT:
PPP Point to Point protocol for a PDP such as IP
PAD Character stream for X.25 character (triple X PAD) mode (Obsolete)
X25 X.25 L2 (LAPB) for X.25 packet mode (Obsolete)
M-OPT-PPP MS supports manufacturing specific protocol
M-HEX MS supports manufacturing specific protocol
M-RAW_IP MS supports manufacturing specific protocol
Other values are not supported and will result in an ERROR response to the execution
command
<cid> A numeric parameter which specifies a particular PDP context definition (see +CGDCONT
command)
AT+CGPADDR Show PDP Address
Test Command
AT+CGPADDR=?
Response
+CGPADDR:[ (list of defined <cid>s)]
OK
Write Command
AT+CGPADDR=<cid>[,<cid>[,…]]
Response
+CGPADDR: <cid>,<PDP_addr>
[+CGPADDR: <cid>,<PDP_addr>[…]]
OK
ERROR
If error is related to ME functionality:
+CME ERROR: <err>
Maximum Response Time
300ms
Reference
3GPP TS 27.007
<cid> A numeric parameter which specifies a particular PDP context definition (see
Quectel
Confidential