Quectel UG Series User Manual

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 176 / 247
Unsolicited result code:
When the presentation of the CLIP at the TE is enabled (and calling subscriber allows), an unsolicited
result code is returned after every RING (or +CRING: <type>) at a mobile terminating call:
+CLIP: <number>,<type>,[subaddr],[satype],[<alpha>],<CLI validity>
Example
AT+CLIP=1
OK
RING
+CLIP: "02151082965",129,,,,0
11.5. AT+CLIR Calling Line Identification Restriction
AT+CLIR refers to the CLIR supplementary service (Calling Line Identification Restriction) according to
3GPP TS 22.081 and the OIR supplementary service (Originating Identification Restriction) according to
3GPP TS 24.607 that allows a calling subscriber to enable or disable the presentation of the calling line
identity (CLI) to the called party when originating a call.
10.5.4.8)
<type> Type of address octet in integer format;
129 Unknown type (IDSN format number)
145 International number type (ISDN format )
<alpha> String type alphanumeric representation of <number> corresponding to the entry
found in phone book
<CLI validity> 0 CLI valid
1 CLI has been withheld by the originator
2 CLI is not available due to interworking problems or limitations of originating
network
AT+CLIR Calling Line Identification Restriction
Test Command
AT+CLIR=?
Response
+CLIR: (list of supported <n>s)
OK
Read Command
AT+CLIR?
Response
+CLIR: <n>,<m>
NOTE
Quectel
Confidential

Quectel UG Series Specifications

General

Brand	Quectel
Model	UG Series
Category	Control Unit
Language	English