Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 215 / 247
1. Parameters will not be saved to NV.
2. When Pin25 is busy, it will return CME error.
12.19. AT+QPCMON Enable PCM Sync & BCLK
AT+QPCMON is used to enable PCM sync & BCLK.
Parameter
This parameter will not be saved.
2 13MHz
3 6.5MHz
4 32KHz
AT+QPCMON Enable PCM Sync & BCLK
Test Command
AT+QPCMON=?
Response
+QPCMON: (list of supported <n>s)
OK
Read Command
AT+QPCMON?
Response
+QPCMON: <n>
OK
Write Command
AT+QPCMON=<n>
Response
OK
ERROR
Maximum Response Time
300ms
<n> Numeric type
0 Close PCM sync & BCLK
1 Enable PCM sync & BCLK
NOTES
NOTE
Quectel
Confidential