Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 45 / 247
The configuration will be saved to NV automatically.
4.3.6. AT+QCFG="urc/delay" Delay URC Indication
AT+QCFG="urc/delay" can delay the output of URC indication until ring line pulse ends.
Parameter
The configuration will be saved to NV automatically.
4.3.7. AT+QCFG="tone/incoming" Enable/Disable Ring Tone
AT+QCFG=“tone/incoming” is used to enable or disable ring tone.
AT+QCFG="urc/delay" Delay URC Indication
Write Command
AT+QCFG="urc/delay"[,<enable>]
Response
If configuration parameter is omitted:
+QCFG: "urc/delay",<enable>
OK
If configuration parameter is entered:
OK
ERROR
If error is related to ME functionality:
+CME ERROR: <err>
Reference
<enable> 0 URC indication will be output when ring line pulse starts
1 URC indication will be output when ring line pulse ends (only the type of ring
line is “pulse”, refer to AT+QCFG="urc/ri/ring",
AT+QCFG="urc/ri/smsincoming" and AT+QCFG="urc/ri/other")
AT+QCFG="tone/incoming" Enable/Disable Ring Tone
NOTE
Quectel
Confidential