Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 20 / 247
Z: 0
S0: 0
S5: 8
S6: 2
S7: 0
S8: 2
S10: 15
OK
2.13. AT&W Store Current Parameters to User Defined Profile
AT&W stores the current AT command settings to a user defined profile in non-volatile memory.
Parameter
<n> 0 Profile 0 to store current parameters
2.14. ATZ Set all Current Parameters to User Defined Profile
ATZ restores the current AT command settings to a user defined profile in non-volatile memory, if one was
storable with AT&W before. Any additional AT command on the same command line may be ignored. ATZ
AT&W Store Current Parameters to User Defined Profile
Execution Command
AT&W[<n>]
Response
TA stores the current parameter settings in the user defined
profile. See Table 8: AT Command Settings Storable with
AT&W.
OK
Maximum Response Time
300ms
Reference
V.25ter
Quectel
Confidential