Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 136 / 247
Parameter
<show> 0 Do not show header values defined in commands +CSCA and +CSMP (<sca>,
<tosca>, <fo>, <vp>, <pid> and <dcs>) nor <length>, <toda> or <tooa> in
+CMT, +CMGL, +CMGR result codes for SMS-DELIVERs and SMS-SUBMITs in
text mode
1 Show the values in result codes
Example
AT+CSDH=0
OK
AT+CMGR=2
+CMGR: "STO UNSENT","",
<This is a test from Quectel>
OK
AT+CSDH=1
OK
AT+CMGR=2
+CMGR: "STO UNSENT","",,128,17,0,0,143,"+8613800551500",145,18
<This is a test from Quectel>
OK
9.15. AT+CSMP Set SMS Text Mode Parameters
AT+CSMP is used to set values for additional parameters needed when a short message is sent to the
network or placed in a storage in text mode.
AT+CSMP Set SMS Text Mode Parameters
Test Command
AT+CSMP=?
Response
OK
Read Command
AT+CSMP?
Response
+CSMP: <fo>,<vp>,<pid>,<dcs>
OK
Write Command
AT+CSMP=[<fo>[,<vp>[,<pid>[,<dcs>]
]]]
Response
TA selects values for additional parameters needed when SM
is sent to the network or placed in a storage when text mode
is selected (+CMGF=1). It is possible to set the validity period
Quectel
Confidential