Quectel UG Series

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 41 / 247
Parameter
4.3.3. AT+QCFG="urc/ri/ring" Ring Line Behavior of RING
AT+QCFG="urc/ri/ring", AT+QCFG="urc/ri/smsincoming" and AT+QCFG="urc/ri/other" control the
behavior of ring line when URC is reported. These configurations will be stored into NV automatically. The
ring line is active low. AT+QCFG="urc/ri/ring" specifies the behavior of ring line when RING is presented
to indicate an incoming call.
The sum of parameter <active_duration> and <inactive_duration> determines the interval time of
“RING” indications when a call is coming.
+QCFG: "uart/power",<uart>,<mode>
OK
If <mode> is not omitted:
OK
ERROR
If error is related to ME functionality:
+CME ERROR: <err>
Reference
<uart> 0 UART 1
1 UART 3
<mode> 0 Auto turn on/off the UART port
1 Turn on the UART port
2 Turn off the UART port
AT+QCFG="urc/ri/ring" Ring Line Behavior of RING
Write Command
AT+QCFG="urc/ri/ring"[,<typeri>[,<pu
lse_duration>[,<active_duration>[,<in
active_duration>[,<ring_no_disturbin
g>[,<pulse_count>]]]]]]
Response
If configuration parameters are omitted
(+QCFG="urc/ri/ring"), return current configuration:
+QCFG:
"urc/ri/ring",<typeri>,<pulse_duration>,<active_duration
>,<inactive_duration>,<ring_no_disturbing>,<pulse_cou
nt>
OK
If configuration parameters are entered:
Quectel
Confidential