UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 150 / 247
Parameter
<Delivery of erroneous SDUs>,
<Transfer delay>,
<Traffic handling priority>,
<Source statistics descriptor>,
<Signalling indication>]
[...]
OK
Write Command
AT+CGEQREQ=[<cid>[,<Traffic
class>[,<Maximum bitrate UL>
[,<Maximum bitrate DL>
[,<Guaranteed bitrate UL>
[,<Guaranteed bitrate DL>
[,<Delivery order>
[,<Maximum SDU size>
[,<SDU error ratio>
[,<Residual bit error ratio>
[,<Delivery of erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling priority>
[,<Source statistics descriptor>
[,<Signalling indication>]]]]]]]]]]]]]]]
Response
OK
ERROR
If error is related to ME functionality:
+CME ERROR: <err>
<cid> PDP context identifier, a numeric parameter which specifies a particular
PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands. The range of permitted
values (minimum value=1) is returned by the test form of the command
<Traffic class> Integer type, indicates the type of application for which the UMTS bearer
service is optimized (refer to 3GPP TS 24.008 subclause 10.5.6.5). If the
traffic class is specified as conversational or streaming, then the
Guaranteed and Maximum bitrate parameters should also be provided
0 Conversational
1 Streaming
2 Interactive
3 Background
4 Subscribed value
<Maximum bitrate UL> Integer type, indicates the maximum number of kbits/s delivered to UMTS
To Next Page
Loading...
Need help?
General
