4 Subscribed value
<Maximum bitrate UL> Integer type, indicates the maximum number of kbits/s delivered to UMTS
(up-link traffic) at a SAP. As an example a bitrate of 32kbit/s would be
specified as '32' (e.g. AT+CGEQREQ=…,32, …)
0 Subscribed value
1~8640
<Maximum bitrate DL> Integer type, indicates the maximum number of kbits/s delivered by UMTS
(down-link traffic) at a SAP. As an example a bitrate of 32kbit/s would be
specified as '32' (e.g. AT+CGEQREQ=…,32, …)
0 Subscribed value
1~16000
<Guaranteed bitrate UL> Integer type, indicates the guaranteed number of kbits/s delivered to UMTS
(up-link traffic) at a SAP (provided that there is data to deliver). As an
example a bitrate of 32kbit/s would be specified as '32' (e.g.
AT+CGEQREQ=…,32, …)
0 Subscribed value
1~8640
<Guaranteed bitrate DL> Integer type, indicates the guaranteed number of kbits/s delivered by UMTS
(down-link traffic) at a SAP (provided that there is data to deliver). As an
example a bitrate of 32kbit/s would be specified as '32' (e.g.
AT+CGEQREQ=…,32, …)
0 Subscribed value
1~16000
<Delivery order> Integer type, indicates whether the UMTS bearer shall provide in-sequence
SDU delivery or not (refer 3GPP TS 24.008 subclause 10.5.6.5)
0 No
1 Yes
2 Subscribed value
<Maximum SDU size> Integer type, (1,2,3,…) indicates the maximum allowed SDU size in octets.
If the parameter is set to '0' the subscribed value will be requested (refer to
3GPP TS 24.008 subclause 10.5.6.5)
0 Subscribed value
10~1500 (value needs to be divisible by 10 without remainder)
1502
1510
1520
<SDU error ratio> String type, indicates the target value for the fraction of SDUs lost or
detected as erroneous. SDU error ratio is defined only for conforming traffic.
The value is specified as 'mEe'. As an example a target SDU error ratio of
5*10
-3
would be specified as "5E3" (e.g. AT+CGEQREQ=…,"5E3",…)
"0E0" Subscribed value
"1E2"
"7E3"
"1E3"
To Next Page
Loading...
Need help?
General
