Quectel UG Series User Manual

UMTS/HSPA Module Series
WCDMA UGxx AT Commands Manual
WCDMA_UGxx_AT_Commands_Manual Confidential / Released 178 / 247
Parameter
OK
Read Command
AT+COLP?
Response
+COLP: <n>,<m>
OK
Write Command
AT+COLP=<n>
Response
TA enables or disables the presentation of the COL
(Connected Line) at the TE for a mobile originating a call. It
has no effect on the execution of the supplementary service
COLR in the network.
Intermediate result code is returned from TA to TE before any
+CR or V.25ter responses.
OK
Maximum Response Time
15s, determined by network.
Reference
3GPP TS 27.007
<n> Parameter sets/shows the result code presentation status in the TA
0 Disable
1 Enable
<m> Parameter shows the subscriber COLP service status in the network
0 COLP not provisioned
1 COLP provisioned
2 Unknown (e.g. no network, etc.)
<number> Phone number in string type, format specified by <type>
<type> Type of address octet in integer format
129 Unknown type (IDSN format number)
145 International number type (ISDN format )
<subaddr> String type sub-address of format specified by <satype>
<satype> Type of sub-address octet in integer format (refer to 3GPP TS 24.008 sub clause
10.5.4.8 )
<alpha> Optional string type alphanumeric representation of <number> corresponding to the
entry found in phone book
Quectel
Confidential

Quectel UG Series Specifications

General

Brand	Quectel
Model	UG Series
Category	Control Unit
Language	English