Radyne ComStream SFC6400A - Show Priority Command (B1: 8); Show Received Signal Strength Command (Upconverter Only)(S, P1:1, P1:8

To Next Page

To Previous Page

Appendix A SFC6400A/SFC1450A Synthesized Frequency Upconverter

A-10 TM106 – Rev. 1.1

A backup converter in a 1:8 Switch Configuration will return the following string of information:

abcdefgh = Priority settings for converters 1 - 8 respectively

0 = None. Backup will ignore converter

1 = Highest priority

8 = Lowest Priority

n = Used with manual backup command MANBACK as follows:

0 = Places the Backup in Standby mode, all Primes

online

1 - 8 Specifies the Prime to be taken offline and replaced

by the Backup

<cr><lf> {End of transmission}

A backup converter in a 1:1 Switch Configuration will return the following string of information:

There are no data specific commands for the backup converter in the one for one switch

configuration

<cr><lf> {End of transmission}

A.4 Show Received Signal Strength Command (Upconverter Only)(S, P1:1,

P1:8)

This command will cause the converter to output the Received Signal Strength.

@01/SHOWRSS<cr>

The converter will return the following:

RSS: vv {vv = value for Received Signal Strength}

<cr><lf> {End of transmission}

A.5 Show Priority Command (B1: 8)

This command returns the priority settings for all 8 of the prime converters. The command is as

follows:

@01/SHOWPRI

The converter will return the following:

Converter 1 2 3 4 5 6 7 8

Priority a b c d e f g h {abcdefgh = Priority settings for converters 1 - 8

respectively}

<cr><lf> {End of transmission}