Radyne ComStream SFC6400A - Dump Calibration Table Set (All); Get Current DAC Value (All); Get DAC Value for Frequency and Gain (All)

To Next Page

To Previous Page

SFC6400A/SFC1450A Synthesized Frequency Upconverter Appendix A

TM106 – Rev. 1.1 A-23

A.35 Dump Calibration Table Set (All)

This command returns the contents (DAC values for all gains) of the Power Calibration Table for the

given Frequency Index. The command is as follows:

@01/DMPCALff<cr>

where:

ff {Index into the frequency array portion of the table}

If successful, the converter will return the following string:

[ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g]

<cr><lf> {End of transmission}

where:

ffff.f {f = frequency for channel entry}

sgg.g {s = ‘+’ or ‘-‘ : gg.g = Gain for channel entry}

A.36 Get Current DAC Value (All)

This command returns the DAC value in use for the unit’s current configuration (Values of

Frequency and Gain). The command is as follows:

@01/CURDAC<cr>

If successful, the converter will return the following string.:

DAC Value = dddd {dddd = DAC Value}

<cr><lf> {End of transmission}

A.37 Get DAC Value for Frequency and Gain (All)

This command returns the DAC value to be used for the given values of frequency and gain. The

command is as follows:

@01/DACFORffff.f gg.g<cr>

where:

ffff.f {f = frequency }

sgg.g {s = ‘+’ or ‘-‘ : gg.g = Gain }

If successful, the converter will return the following string.: