Radyne ComStream SFC6400A - Connecting the Terminal; Ethernet Port Configuration; Ethernet Port User Interface

To Next Page

To Previous Page

User Interfaces SFC6400A/SFC1450A Synthesized Frequency Upconverter

4-36 TM106 – Rev. 1.1

4.6 Ethernet Port User Interface

The Ethernet Port allows for complete control and monitoring of all Upconverter parameters and

functions via a 10BaseT or 100BaseT Ethernet connection.

4.6.1 Ethernet Port Configuration

4.6.1.1 Connecting the Terminal

1. Connect a computer serial port ( or dumb terminal port) to the SFC Upconverter Terminal

Connector (J6) on the rear of the unit.

2. Verify that the emulation software is set to the following:

VT100

9600 baud

8 data bits

no parity

1 stop bit

Modify the Upconverter selection, if necessary, to match the settings (Front Panel Menu:

System>Terminal>).