User Interfaces SFC6400A/SFC1450A Synthesized Frequency Upconverter
4-42 TM106 – Rev. 1.1
4.6.2.10 Converter IP Address
1. Select ‘39’, Converter IP Address:. Enter the SFC Upconverter Internet Address in dot
notation and press <ENTER>. Please consult your network administrator for valid
addresses.
Example - 192.168.0.35
2. The IP Address that is selected will be used for the Ethernet Test that follows.
4.6.2.11 Server Ethernet Address
This section refers to the boot host.
1. Select 40.ServerEthAddr:. Enter the Server 12 Digit Ethernet Address and press
<ENTER>. Zero out this address if not known at this time. The system will resolve it
dynamically at run time.
Example: 0FD0640203ED or 000000000000
4.6.2.12 Server IP Address
This section refers to the Host that will be used to optionally boot the Upconverter on power-up. The
host should be acceptable to the transport layer. In other words, the transport layer needs to be
able to open a connection to the entity specified by the server IP Address field.
1. Select 41.ServerIPAddr :. Enter the Server Internet Address in dot notation and press
<ENTER>. Please consult your network administrator for valid addresses.
Example: 192.168.0.50
2. The IP Address that is selected will be used for the Ethernet Test that follows.
4.6.2.13 Router IP Address
Select 42.RouterIPAddr :. Enter the router Internet Address in dot notation and press <ENTER>.
Please consult your network administrator for valid addresses.
Example: 192.168.0.254
4.6.2.14 IP Address Mask
In the mask (more clearly seen in the binary format), binary 1s indicate the position of the network
and subnet portion of the IP Address while binary 0s identify bits that represent the individual
interfaces. To recognize a subnet, each system in the subnet must have the same subnet mask.
Please consult your network administrator for a valid address class mask.
1. Select 43.IPAddressMask:. Enter the IP Address mask in dot notation and press
<ENTER>.
Example: 255.255.0.0
To Next Page
Loading...