Radyne ComStream SFC6400A - Remote Help Menu (All)

Appendix A SFC6400A/SFC1450A Synthesized Frequency Upconverter
A-2 TM106 – Rev. 1.1
A.1 Remote Help Menu (All)
The following command returns information on all remote serial commands. The command is as
follows:
@01/HELP<cr>
A single converter or a prime converter in 1 for 8 configuration will return the following:
For Upconverter:
<cr><lf>
HELP Show all commands
DATA Show data associated with commands
STATUS Show status
RFOFF Mutes the output
RFON Unmutes the output
CLRFAULT Clears any stored faults
DUMPADC Dump ADC data
ERASE Erases saved data when the converter is restarted
RESTART Restarts the converter
SETCHANcc Retrieve specified channel
SETFREQffff.t Set current channel's frequency
SETGAINsgg.g Set current channel's gain
SETATTNaa Set converter input attenuation
STORE Save current channel's frequency & gain
RAMGAINccsgg.g Set stored gain for the specified channel
RAMFREQccffff.t Set stored frequency for the specified channel
<cr><lf>
<cr><lf> {End of transmission}
For Upconverter:
<cr><lf>
HELP Show all commands
DATA Show data associated with commands
STATUS Show status
SHOWRSS Displays the received signal strength
CLRFAULT Clears any stored faults
DUMPADC Dump ADC data
ERASE Erases saved data when the converter is restarted
RESTART Restarts the converter
SETCHANcc Retrieve specified channel
SETFREQffff.t Set current channel's frequency
SETGAINsgg.g Set current channel's gain
SETATTNaa Set converter input attenuation
STORE Save current channel's frequency & gain
RAMGAINccsgg.g Set stored gain for the specified channel
RAMFREQccffff.t Set stored frequency for the specified channel
<cr><lf>
<cr><lf> {End of transmission}
A prime converter in a 1 for 1 configuration will return the following: