SFC6400A/SFC1450A Synthesized Frequency Upconverter Appendix B
TM106 – Rev. 1.1 B-1
Appendix B – Remote RLLP
When new features are added to Radyne ComStream Corporation
equipment, the control parameters are appended to the end of the Non-
Volatile Section of the Remote Communications Specification, and status of
the features, if any, are added at the end of the Volatile Section. If a
remote M&C queries two pieces of Radyne ComStream Corporation
equipment with different revision software, they could respond with two
different sized packets. The remote M&C MUST make use of the non-
volatile count value to index to the start of the Volatile Section. If the
remote M&C is not aware of the newly added features to the product, it
should disregard the parameters at the end of the Non-Volatile Section and
index to the start of the Volatile Section.
Before creating any software based on the information contained in this
document, contact the Radyne ComStream Corporation Customer Service
Department (602-437-9620) to find out if the software revision for that piece
of equipment is current and that no new features have been added since
the release of this document.
B.1 Converter Opcode Command Set
The converter opcode command set is listed below:
Command Opcode
Query module identification 2403h
Query control mode 2404h
Query software revision number 3004h
Query firmware part number and release date 3005h
Query time 240Eh
Query date 240Fh
Query time and date 2410h
Query converter status 3000h
Query converter configuration 3001h
To Next Page
Loading...