Radyne ComStream SFC6400A - Dump Channel Table (All); Get Gain Offset (Upconverter Only); Set Gain Offset (Upconverter Only)

To Next Page

To Previous Page

Appendix A SFC6400A/SFC1450A Synthesized Frequency Upconverter

A-22 TM106 – Rev. 1.1

A.32 Get Gain Offset (Upconverter Only)

This command displays the value for the Gain Offset. The command is as follows:

@01/GAINOFFSET?<cr>

If successful, the converter will return the following string:

Gain Offset Value = gg: {gg is the gain offset value}

<cr><lf> {End of transmission}

A.33 Set Gain Offset (Upconverter Only)

This command sets the value for the Gain Offset. The command is as follows:

@01/GAINOFFSET = <cr>

If successful, the converter will return the following string:

Gain Offset Value = gg: {gg is the gain offset value}

<cr><lf> {End of transmission}

A.34 Dump Channel Table (All)

This command returns the contents of the Channel Table. The command is as follows:

@01/DMPCHAN<cr>

If successful, the converter will return the following string:

[ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g] [ffff.f,sgg.g]

<cr><lf> {End of transmission}

where:

ffff.f {f = frequency for channel entry]

sgg.g {s = ‘+’ or ‘-‘ : gg.g = Gain for channel entry]