R&S EM510 - Operating Modes and Control Parameters

EM510 Characteristics
4065.7763.32-01.00 2.2
2.2 Operating Modes and Control
The Fixed Frequency Mode is the standard mode of the receiver. In this mode a fixed frequency
channel is set at which the signal is received, filtered and demodulated.
The following parameters can be set:
 Frequency
Setting range from 9 kHz to 32 MHz in 1 Hz steps
 Demodulation mode
The following demodulation modes can be selected:
– FM
– AM
– PULSE (AM PULSE)
– PM
– USB
– LSB
– ISB
– CW
– I/Q
 Bandwidth
The IF bandwidths can be selected in 30 steps between 100 Hz and 10 MHz.
 Measurement time (automatic or settable between 0.5 ms to 900 s)
 Detector modes "continues" or "periodic"
 Squelch
The level squelch can be set in 1 dB steps in the range from -30 to +130 dBµV.
 AFC (Automatic Frequency Control)
With AFC switched on, the receiver frequency is tuned within the IF bandwidth.
 Level detector
For level measurement the detector can be switched to AVG, PEAK, RMS or FAST.
 Frequency offset detector
 Attenuator
The attenuator operates in manual (0 to 25 dB) or automatic mode.
 Gain control (GC)
Automatic (AGC) and manual (MGC) gain control is selectable.
The MGC setting covers the input signal range from -30 to 130 dBµV.
 Video Panorama
Spectrum of the demodulated signal with analysis features (squared AM, FM)
 IF Panorama (Option)
Independent from IFBW, settable from 10 kHz to 9.6 MHz
 ITU Measurement (Option)
AM modulation index (AM+, AM-, AM)
FM deviation (FM+, FM-, FM)
PM deviation (0 to 4π)
Bandwidth (0 to 9.6 MHz)