R&S EM510 - External Reference, Headphones, and PC;LAN Connections

Installation and Cabling EM510
3.5 4065.7763.32-01.00
3.5.3 Connection of External Reference (optional)
The EM510 can be set to synchronize to an external frequency. To do so, apply the reference signal for
the synchronization to socket X9 REF IN on the rear panel.
- Frequency range: 1 to 20 MHz
- RF level: 0 to +10 dBm
- Z = 50 
Note: If MIL-Spec regarding EMC must be fulfilled, a double screened connecting cable is
necessary.
3.5.4 Connection of Headphones (optional)
Connect the headphones to HEADPHONE socket X10 AF on the front panel.
- V
pp
max = 5 V
- R
i
= 100 
3.5.5 Connection of PC or LAN for Remote Control
 Use a LAN crossed-over cable (point-to-point connection) with RJ45 connector to connect the
Ethernet port of the PC directly to the socket X11 LAN (ETHERNET 10/100 BASE-T, RJ45 8-pin
connector) on the rear panel of the EM510.
or
 Use a LAN patch cable with RJ45 connector to connect the hub or network to the socket X11 LAN
on the rear panel of the EM510.