Installation and Cabling EM510
3.1 4065.7763.32-01.00
3 Installation and Cabling
The EM510 is supplied completely assembled except for the handles and mounting brackets (use in
rack), which come separately and must be attached by the user.
3.1 Unpacking and Checking
Unpack the EM510.
Remove the packing material.
Remove the transport shells.
Check all delivered items according to the delivery note.
Screw on the side handles.
Check the EM510 for visible damage that may have been caused in transit.
Contact the transport agents immediately if damage is found.
Note: Keep the packing material for re-use!
3.2 Safety Precautions
Caution: Switching the unit off by means of the POWER switch on the front panel does not
separate the unit from mains power. The mains voltage of 100 to 240 VAC is highly
dangerous. Therefore proceed with extreme care when handling such voltages.
When fitting operating rooms and installing and operating electrical equipment, the relevant national
and international safety provisions and regulations have to be adhered to.
The following safety instructions apply in particular:
IEC 364
VDE 0100
DIN 57100
These safety regulations deal with the following subjects:
Protection:
Prevention of accidents
Protection against overvoltage
Insulation of equipment
Grounding
Characteristics and laying of lines and cables
Provisions for operational facilities and rooms and systems of a special nature.
To Next Page
Loading...
