R&S EM510 - Status:operation:sweeping Register

EM510 Remote Control via LAN
4065.7763.32-01.00 5.136
5.5.3.5 STATus:OPERation:SWEeping Register
This register contains further information about the status of the device. The device is either in normal
reception (fixed frequency) or in one of several scan modes (FSCAN, MSCAN, PSCAN).
The state is determined by the SENSe:FREQuency:MODE command with the CW|FIXed state being
characterized by deleting bits 3 to 5 in the STATus:OPERation:SWEeping register.
Table 5-4: Bit allocation of STATus:OPERation:SWEeping register
Bit No. Meaning
0 Hold
This bit is set if a FSCAN or MSCAN was interrupted by a fulfilled hold condition.
1 Running up
This bit is set if scanning is to be carried out to increasing frequency values or memory locations.
2 Running down
This bit is set if scanning is to be carried out to decreasing frequency values or memory locations.
3 FSCAN active
This bit is set if FREQ:MODE is set on SWEep.
4 MSCAN active
This bit is set if FREQ:MODE is set on MSCan.
5 - 7
reserved
8
PSCAN active
This bit is set if FREQ:MODE is set on PSCan (software option EM510PS).
9
reserved