R&S EM510 - ROUTe Subsystem: Signal Path Management

EM510 ROUTe Subsystem
4065.7763.32-01.00 5.56
5.3.14 ROUTe Subsystem
Two signal path switches (signal routing) are equipped in the EM510.
The command ROUTe without numeric suffix or with numeric suffix 1 is used for the antenna selector 1
to 99.
The command ROUTe with numeric suffix 2 is used for the crosspoint switch for Gigacast, FPDP and
the regenerating paths.
ROUTe
. :CLOSe <channel_list>
Selection of an antenna; the previous antenna has to be switched off with ROUTe:OPEN:ALL (also see
ROUTe:SELect)
Error message:
If more than one antenna is to be selected, an execution error -221,"Settings conflict" will be
generated.
Parameters:
<channel_list> may contain max. one number (0 to 99)
*RST state:
@1
Example:
ROUTe:CLOSe (@23)
. :CLOSe? <channel_list>
Query about whether the corresponding antenna has been selected.
Parameters:
<channel_list> contains a value for each antenna number to be queried
Result:
0 for each non-selected antenna number
1 for each selected antenna number
Example:
ROUTe:CLOSe? (@2, 10:12, 23) -> 0,0,0,0,1
. . :STATe? [MINimum|MAXimum]
Query about the antenna that has been selected.
Parameters:
none query about the currently selected antenna
MINimum|MAXimum query about the lowest|highest antenna number
Result:
Antenna number as a <Definite Length Block>
Example:
ROUTe:CLOSe:STATe? -> #15(@23)