R&S EM510 - Preparation for Use and Firmware Update; Power Up and Local Control

Preparation for Use EM510
4.1 4065.7763.32-01.00
4 Preparation for Use
4.1 Power Up
Attention:
Before switch-on:
- Check that the available mains voltage is between 100 and 240 VAC.
- Check that the available supply voltage is between 12 and 32 VDC.
The EM510 is switched on via the POWER switch.
The POWER LED lights up after switch-on.
4.2 Local Control
Except for the POWER LED and POWER switch the EM510 has no control elements.