EM510 Remote Control via LAN
4065.7763.32-01.00 5.124
Example 1:
Remote client 1 modifies the frequency value. The central memory signals to the receiver that a new
frequency is to be set. The remote client 2 (if connected) is supplied with the new frequency. Every
remote client receives a modification report (see "STATus:EXTension Register" on page 5.139).
Example 2:
If the receive frequency is changed by the receiver due to a scanning procedure or an AFC correction,
this is reported to remote clients 1 and 2.
5.4.1 Remote Client
Input unit with
buffer memory
Output unit with
buffer memory
Command detect
Status reporting
system
To data memory
Socket
Figure 5-3: Structure of a remote client within the firmware
To Next Page
Loading...
