R&S EM510 - Page 91

OUTPut Subsystem EM510
5.55 4065.7763.32-01.00
. :VIDeo:MODE IF|DEModulator
The video-mode switch determines whether the analog IF or the analog demodulated video signal is
output at the front panel through one of the connectors "Video A X6" or "Video B X7". In the case of an
analog IF, the center frequency can be set by the OUTPut:VIDeo:FREQuency command.
Parameters:
IF output of the analog IF
DEModulator output of the analog demodulated video signal
*RST state:
DEM
Example:
OUTPut:VIDeo:MODE IF
. : :VIDeo:MODE?
Query about the current video mode.
Parameters:
none
Result:
IF output of the analog IF
DEM output of the analog demodulated video signal
Example:
OUTPut:VIDeo:MODE?  IF