R&S FSH series User Manual

122
PD 1309.6269.62-02
When the GPS Receiver Function is enabled and
there is no fi x connection, this symbol is shown:
and the GPS information bar is red:
When the GPS Receiver Function is enabled and
there is no receiver connected (or not connected
properly, or the receiver is defective), this symbol is
shown:
and the GPS information bar is red:
When the GPS Receiver is not enabled, no symbol
is shown.
When the device is booted with GPS enabled and
GPS mouse connected, the user is questioned
whether to restore the GPS information (latitude,
longitude and correction factor) of the device just
before it was shut down, or to fl ush this data and
start with unknown position and correction factor.
This is depicted in the messagebox below:
GalaxyE_v1-10_3.indd 122GalaxyE_v1-10_3.indd 122 08.04.2009 15:21:5408.04.2009 15:21:54

R&S FSH series Specifications

General

Input Impedance	50 Ω
Display	640 x 480 pixels
Tracking generator	Optional
Interfaces	USB, LAN
Third Order Intercept (TOI)	+15 dBm typical
Input VSWR	≤1.5:1 (typical)
Input Connector	N (f)
Power Supply	100 V to 240 V
Frequency range	9 kHz to 3.6/8/13.6/20 GHz
Battery life	Approx. 4 hours (standard battery)