R&S FSH series User Manual

59
E-02
2.7 Enabling Options
The R&S FSH can be fi tted with options (e.g.
distance-to-fault measurements on cables) which
are enabled by entering a key code. The key code
is based on the unique serial number of the
instrument. To add an option, enable it with a key
code.
Operation
 Press the SETUP key.
 Press the INSTALLED OPTIONS softkey.
 Select INSTALL OPTION... under the OPTION
ADMINISTRATION header.
 Confi rm with ENTER.
An entry box in the lower right corner of the screen
is displayed.
 Type in the the appropriate option key.
 Confi rm with ENTER.
If the key entry was successful, the following
notifi cation is given in the bottom of the screen:
If the key entry failed, the following notifi cation is
given in the bottom of the screen:
The correct key code can then be entered.
GalaxyE_v1-10_3.indd 59GalaxyE_v1-10_3.indd 59 08.04.2009 15:21:4408.04.2009 15:21:44

R&S FSH series Specifications

General

Input Impedance	50 Ω
Display	640 x 480 pixels
Tracking generator	Optional
Interfaces	USB, LAN
Third Order Intercept (TOI)	+15 dBm typical
Input VSWR	≤1.5:1 (typical)
Input Connector	N (f)
Power Supply	100 V to 240 V
Frequency range	9 kHz to 3.6/8/13.6/20 GHz
Battery life	Approx. 4 hours (standard battery)