R&S NRP8S - Page 94

Remote Control Commands
R&S
®
NRPxxS(N)
94User Manual 1177.5079.02 ─ 10
Using [SENSe<Sensor>:][POWer:][AVG:]FAST ON, you can accelerate the mea-
surement as follows:
●
Chopper is deactivated.
●
Average count is set to 1, no matter which average count you have set.
Thus, the overall measurement time is only defined by the aperture time, and the mea-
surement time for a fast measurement is calculated as follows:
MT = APER
A programming example is given in Chapter 10.2, "Performing the Fastest Measure-
ment in Continuous Average Mode", on page 144.
Remote commands:
[SENSe<Sensor>:][POWer:][AVG:]APERture......................................................................94
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:CLEar...............................................................94
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:COUNt?............................................................94
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:DATA?.............................................................. 95
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:SIZE.................................................................95
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:STATe...............................................................95
[SENSe<Sensor>:][POWer:][AVG:]FAST............................................................................ 95
[SENSe<Sensor>:][POWer:][AVG:]SMOothing:STATe..........................................................96
[SENSe<Sensor>:][POWer:][AVG:]APERture <integration_time>
Sets the duration of the sampling window in the continuous average mode. During this
time interval, the average signal power is measured.
Parameters:
<integration_time> Range: 10.0e-6 to 2.00
*RST: 0.02
Default unit: Seconds
Example:
APER 0.02
Manual operation: See "Aperture Time" on page 45
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:CLEar
Clears the contents of the result buffer in continuous average mode.
Example:
BUFF:CLE
Usage: Event
[SENSe<Sensor>:][POWer:][AVG:]BUFFer:COUNt?
Queries the number of results that are currently stored in the result buffer. Available in
continuous average mode.
Example:
BUFF:COUN?
Usage: Query only
Configuring the Measurement Modes