Chapter 3: Using the Web Interface
Information General device information, such as model
name, serial number, firmware version,
hardware revision, MIB download link(s) and
so on.
Note that the download link of LHX-MIB is
available only after enabling the Schroff
LHX/SHX support. See
(on
page
303).
Network The network in
formation, such as the current
networking mode, IPv4 and/or IPv6
addresses and so on.
This tab also indicates whether the BCM2 is
part of a cascading configuration. See
Identifying Cascaded Devices
(on page 308).
Port Forwarding If the port forwarding mode is activated, this
section will show a list of port numbers for
all cascaded devices.
Outlets Each outlet's receptacle type, operating
voltage and rated current.
Overcurrent Protectors Each overcurrent protector's type, rated
current and the outlets that it protects.
Controllers Each inlet or outlet controller's serial
number, board ID, firmware version and
hardware version.
Inlets Each inlet's plug type, rated voltage and
current.
Peripheral Devices Serial numbers, model names, position and
firmware-related information of connected
environmental sensor packages.
Asset Management Each asset strip's ID, boot version,
application version and protocol version.
To Next Page
Loading...
