Chapter 2: Connecting External Equipment (Optional)
b. Connect the adapter's RJ-45 connector to the RJ-45 SENSOR
port of the BCM2.
OR you can directly connect the DPX2 sensor package to a DX sensor
chain without using any RJ-12 to RJ-45 adapter. See
Connecting a
DPX2 Sensor Package to DX
(on page 59).
DPX3 Sensor Packages
A DPX3 sensor package features the following:
• Its connection interface is RJ-45.
• You can cascade a maximum of 12 DPX3 sensor packages.
RJ-45 ports, each of which is located on
either end of a DPX3 sensor package.
LED for indicating the sensor status.
To connect DPX3 sensor packages to the BCM2:
1. Connect a standard network patch cable (CAT5e or higher) to either
RJ-45 port on the DPX3 sensor package.
2. If you want to cascade DPX3 sensor packages, get an additional
standard network patch cable (CAT5e or higher) and then:
a. Plug one end of the cable into the remaining RJ-45 port on the
prior DPX3.
b. Plug the other end into either RJ-45 port on an additional DPX3.
To Next Page
Loading...
